System Disinfecting If System is used to dark hunter fantasy lover pdf supply RO drinking water for human consumption disinfection is recommended.
Due to it's dual stage filtration system, these filters resist clogging.Within 2-5 minutes RO water will start flowing out of the blue tubing.WM-120 replacement membranes: Part #WP MEM -TFM-75 gpd WM-120 membranes depending on water conditions should be replaced once every 12 to 24 months.Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.R310 Manuel dutilisation et dentretien.(See figure 9A) When the filter has dropped into the grooves, twist the filter 45 degrees according to the arrow on the filter tray to lock and seal the filter into place.Install system on a firm level floor away from radiators.Start-up (a) Disconnect the blue tubing from the pressurized storage tank or from the posttreatment equipment that it is connected.Allow the system to stand in an upright position for at least 30 minutes before turning on the power to allow all cooling refrigerant to settle.C) 3/8 OD Red Polyethylene tubing is for connecting to a drain.1 Watts Pure Water Systems WM-120-PT Installation and Operation Manual Premier Water Systems Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.B) The WM-120 will have an approximate weight of 75 pounds.Manufacturers Manuals Pull Sheets.Use this system only for its intended purpose as described in this use and care guide.
Save these instructions for future use.
The WM-bracket will slide between the screw head and the wall.
Drain Saddle Connection.
This pressure must be reduced.
(f) Add 1 teaspoon of hydrogen peroxide to storage tank, by removing tank tee from the storage tank or by adding hydrogen peroxide to the line social media report 2012 pdf feeding into the storage tank.
WM-120 Polyethylene tubing is color coded for easy installation.
(a) Turn off the supply water.To drain 3 4 Step 1: Location a) WM-120 to be mounted to a wall with feed water supply, drain and storage tank within.Monday Thurs Friday: 8:00 AM 5:00 PM Mountain Standard Time Watts Water Systems 9 B C : Incoming Feed Water Green Tubing (15 feet) 9: Membrane Feed Ball Valve Brass F 2: Elbow-Plastic C x M 90 o 10: Elbow-Plastic C x M.(j) Close faucet and open any valve that may have been closed.Note: A filterhousing wrench may be need.The blue plastic tubing is the line the RO water flows through from the WM-120.Step 3: Connecting to Feed water supply: The WM may come with either a Self-Piecing Valve, or Easy Tap Adapter.Close supervision is necessary when system is used by or near children.Figure C2 Figure C Sink faucet Delrin Sleeve Valve Handle Brass nut Brass Insert Rubber Gasket Gasket 1/4 green tubing Lance 3/8 cold water line For water line sizes greater than 3/8 Brass insert Delrin sleeve Brass Nut Tubing Easy Tap Valve Processor B Installing.(f) Open the ball valve feeding into the WMmembranes.(c) Open the ball valve at the flush line connection, making sure that the black flush line is in a pail, sink or drain.(Ounces per minute X gallons per 24 hours) Water temperature and water pressure will vary the production.